MOSIN NAGANT 1" RUBBER BUTT PAD

Installation Instructions

 

Remove the old metal butt plate by removing the 2 slotted butt plate screws, Place the new rubber butt pad against the stock and check the pad for a flush fit, Then bend the New butt pad with your hands to fit flush with the stock as needed, Once u have the pad shaped for the best fit, Place the pad against the stock to reinstall - be sure to install the bottom screw first for best alignment, then stand rifle up on the butt pad and push down on rifle for the best and straightest alignment of the top screw, then tighten both screws up snug - Remember these butt pads are sand able, so if you are real picky and want a real nice flush fit at the bottom of the pad, were the butt pad and rifle stock meet - you can sand the pad as need.

 

 The Gun Garage, Inc  "Reg U.S.TM" - Copyright 1999-2009 NoveltyGuns, All Rights Reserved